Rear Lights

Fitting the rear lights wasn't too challenging compared to the front main lights. The back plates just needed a good clean up and polish.

I really focused on polishing where the bulbs fit so to get maximum light reflection. The rest of this back plate is covered by the out foam gasket.

Once done it was time to fit them on to the car. Need to fit the new foam gaskets first as the old ones were no longer up to the job.

Easy to fit on the back.

Then you can fit on the car by tightening the nuts inside the the rear wing.

It's then simple to fit the bulbs, the outer gasket, lens and chrome rim which clips on at the top and then a long screw holds it all in place.

Looks great!