Sunday 5 February 2017

Right Hand Outer Sill in!

At long last the outer sill in all welded in and looking good!

I then needed to complete a repair to the point where the wheel arch meets the sill, as there was some rust in that area I had to cut it out, make a new section and weld it all in.

The issue I need to resolve is to close up all the gaps as I can see no reason to keep this as it is. The only reason I left a gap was because there is one on the left hand side and from photo's I have seen online there is also a gap. Why leave a gap where water from the wheel arch can come through the gap down to the A post? More research required!