Thursday 7 September 2017

Reinforcement Arch to Boot Floor Repair

Continuing on with the whole rear wheel arch repairs tonight, it was more of the same of making a template out of sheet steel, cutting out the rusted metal and then welding in the new. But for some reason I was really enjoying myself. I think it comes from a real sense of confidence that I am gaining from making very good progress with one of the worst areas on the whole MG Midget. 

Another thing that seems to be helping me is that the welder is behaving at the moment. I guess I have it set up just right, but I am managing to weld at odd angles and even upside down has been ok. Long may it last! My confidence that is...and not the time it is taking.

Back to the repair. As you can see from the photos the reinforcement arch needed some attention.




Make up the template.





and cut out the rusty section.





Loving my new Dremel 3000!





Template seems to fit ok but I needed to close those gaps





Offered up the new repair...






...and welded it in





Making sure that it was all flush so the floor makes a good fit.





I'll grind down the welds a little later on.




Happy with that job! Next on the list will be to weld in the inner wheel arch repair I made a few weeks back.



Tuesday 5 September 2017

Rear Wheel Arch Chassis Member Repair

This was one of those repairs that for some unknown reason I wasn't looking forward. I think it stems back to when I first removed the patch repair panels done by a previous owner.



Yes that would be the reason! I remember really questioning my ability to restore the MG Midget back then. I was also very worried about the rear suspension mount but it looked like the rust had stopped just before the join.

Well I stuck to what I had learnt so far, cut out the old and make or buy a new panel and weld it in...simple!

I cut a 32cm x 2.5 cms length and copied the curve


Once the curve was correct I marked out the flange which welds to the floor panel...

 
...and welded the two together


Then I offered it up and it fitted well


Before welding it I had to make sure it was perfectly level with the rear suspension mounts


All welded in and looking much better!


Even the new dog seems impressed...or is he wondering where his dinner is?