Cross Member Completed

After a few recent cold days that brought some snow it has been a balmy 6 degrees in the garage so I was able to finish off welding in the cross member. It is so important to take loads of measurement beforehand to tackle this properly, but it also handy to have a good eye for a straight line as well.

Before that thought I need to make good some of the flanges on the box sections. This was were the rust had penetrated a little too deep into the metal.

It didn't take too long to cut out the old and weld in the new. Certainly looking much better than when I first uncovered this box section.

It took a while to make sure all was straight. After a short time it was in!

Ready to move on to the next area, the end of the foot well.