Passenger Footwell

Been soldiering on with cleaning up the passenger foot well in the MG Midget. Overall the metal is in quite good condition when compared to the drivers side. With a couple of small rust holes that are easily dealt with by the usual process of cutting out the rust and welding in a small piece of metal.

The point at which the inner sill makes contact with the end panel though did need to be sorted out though.

Once the new section was welded back in it allowed me to check the alignment of the inner sill, which thankfully looked good to me.

Also good to check the alignment of the floor panel as well

Next job will be to sort out the foot well side panel and the A-post that looks in as bad a state as the drivers side!