Tuesday, 8 August 2017

Lower Rear Panel Repair Continued

Tonight I continued to work on the rear panel and shaping the custom replacement panels. Having the new boot floor panel really helps me work out the angles and gaps needed to get a good finish.




I have found that plasterers tape is very good for marking out the cutting area as the square mesh helps me see if I am cutting straight or not.



Test fitting is so important, but it looks ok. I had to make a flange at the bottom to ensure it welds correctly on to the boot floor panel.



A few tack welds to keep it in place



Hopefully get the other half in Thursday night.

No comments:

Post a comment