Thursday, 10 August 2017

Lower Rear Panel Repair Continued

Further work tonight on the lower rear panel and managed to weld in the 80cms strip.

I'll finish grinding down the welds to a smooth finish and then make sure the curve is good. I think this has turned out well and an important section to do so that I have got an edge to weld the boot floor too when I get to that stage.

I need to figure out what section I need to focus on next. I am thinking the offside wheel arch is really bad, so I will spend a couple of days having a think about that.

Tuesday, 8 August 2017

Lower Rear Panel Repair Continued

Tonight I continued to work on the rear panel and shaping the custom replacement panels. Having the new boot floor panel really helps me work out the angles and gaps needed to get a good finish.

I have found that plasterers tape is very good for marking out the cutting area as the square mesh helps me see if I am cutting straight or not.

Test fitting is so important, but it looks ok. I had to make a flange at the bottom to ensure it welds correctly on to the boot floor panel.

A few tack welds to keep it in place

Hopefully get the other half in Thursday night.

Monday, 7 August 2017

Lower Rear Panel Repair

I started to create a custom repair for the rear panel. After cleaning all the old paint and filler I measured and the rust was 99% contained within a 5cms width gap. 

I made the decision to make a 80cms strip that would be welded in place after cutting out the rusted area. I will make separate repairs for each section under the rear lights housing later on.


I really enjoy shaping the metal to fit.

Rear Panel Inspection

The rear panel has two main damages areas. The first is where is is connected to the boot floor as you can see from the photos below.

The second is the damage to the offside (right) rear lights housing which is pointing inwards.

The only option I could see was to cut the rear panel away from the rear lights housing.

That allowed me to persuade (bang with the hammer) the lights housing to go back more or less inline to its original position.

I will need to spend a lot more time to get this right but for now I am happy that I am confident I can restore this panel back to its original shape which is necessary to get the new floor in place.

Inner Rear Wheel Arch Repair

A new section brings new challenges. The wheel arch has a nice little curve to it that I suppose is designed to allow the water and mud to flow away. 

Obviously not quick enough in my example...

So a custom repair is needed as a new panel seems more than I require, which I suppose is a positive. It gave me another chance to create a custom panel that I love making up.

First create the templates.

Then cut and shape the metal.

Weld it all together.

Looks good so far!

Thursday, 3 August 2017

A rather rusty bottom

The title says it all really...


Must keep positive


Oh it's more like a horror movie

Think I need some more panels!!

Wednesday, 2 August 2017

Outer rear wing inspection

In order to start removing the patch welding from the Midget's boot floor I need to check the outer rear wing as I suspected that the inner wing repair was attached to the outer wing panel.

I knew there was some filler behind that paint! This explains why this section of the wing bends inwards that I will need to straighten somehow. I would think some sort of reversing mishap or a shunt from behind? Who knows

I have to say that I am quite relieved that this is the extent of the damage to the outer wing. I had imagined the filler and holes to be much higher than this. It will be much easier to retain the original shape.