Having completed welding in the new rear bulkhead on the right side of the Midget, it was time to move on to the next section of the chassis that needs attention, the cross member. Compared to the panel that I have been working on for the last few months, I am expecting this repair to be over in a blink of an eye in comparison.
The main issue is to make sure that the new part goes on perfectly in line with what's left of the original.
This evening I started to cut away more of the rusted section and measure out the new repair.
Once this has been completed I will move on to the footwell end panel which will take some time to get right.
No comments:
Post a Comment