Tuesday, 1 December 2020

First Round of Paint

To continue with the plan of making the MG Midget a rolling chassis so that I can get it to the paint shop without damaging the work I have already completed I needed to paint some key areas of the chassis. 

The idea is to repeat the process of the underside of the chassis, as in completing the seam sealing on all panel joins and then paint, leaving the main external body for the professionals.


I decided to use a brushable seam sealer that when dry can be sanded and painted over. I have found Granvilles G-Pro product was very easy to apply and dried very quickly. That still didn't help though with the amount of edges that needed to be sealed. I spent ages inside the cockpit and the engine bay making sure the every edge was done. 

Please make sure you follow the safety advice when using this product as it does have a strong glue like smell. I used an filtered face mask when applying.


When you use the brush it is difficult to get a smooth finish and if there are sections that are going to be on show you can use a tool, similar to a bathroom silicone sealer tool to smooth the product down immediately after brushing on. I found this made the sealer last much longer as you can push the product into the joint and along at the same time, whereas with the brush it is harder to force it into the joint or gap. 

After a few hours over a couple of evenings I had completed all the areas.







The next step is to prepare the chassis for its first coat of paint. I decided to get the cockpit ad boot done to avoid any stray black paint on the outer Old English White paint. 

First job was to sand down the primer and any rough dried sealer to provide a key for the new paint to stick to. I used 200 grit sandpaper and gave it a good once over. Then hoovered up all the dust as best I could. Then using a specialist paint cleaning solvent and lint free cloths I sprayed and wiped down all surfaces and allowed to dry. The aim is to remove any grease or dust particles that can affect the paint adhering to the primer and sealer. This should be done each time between coats using finer sand paper each time, before you get to the final top coat.

It does take time to do all this preparation, but what's a couple more hours after 8 years!

Now my thinking is that partly to save some money but also to put the best protection on these inner panels which are prone to rusting I have decided to just use more satin black chassis paint on any panel that is going to be covered by nice new carpet or interior trim panels. I think it turned out quite well so far.







Next up will be the engine bay with nice new Old English White paint.

2 comments:

  1. I just spent 8 hours reading your blog. I cannot express my gratitude for your hard work, blog and for helping me on restoring my Midget through your experience. Keep up the good work.

    ReplyDelete
  2. You're very welcome and thank you for the kind words.

    ReplyDelete