Monday 18 December 2017

Boot Floor Test Fitting

I really don't know where the last two months have gone, but getting into the garage has just seemed to be very difficult lately. Sometimes it just goes that way, but once again it is the readers of the blog that encourage me to get back to the task. I thank you all!

The current objective is to repair the whole boot floor and rear wheel arches which were and, in places still are in a terrible state. So after sorting out the suspension bump stop plate on the right hand side I really wanted to turn my attention to test fitting the new boot floor repair panel.



Before I could put this in its correct place the bump stop plate on the left hand side needed to be removed, which really did need to be done because there was some rust damage, certainly not as bad as the right hand side but all the same I can't leave it as it is.



It is a relief that the rust is limited in this area. So with the wire brush attachment and the weld drill bit  I cleaned up the whole area and removed the stop plate, which I will clean up and weld back on when the new floor panel is in place.

Once that was all done I started to measure up as I needed to cut the new panel to fit the rather large hole.


Once cut I was so happy to see that the new panel slotted into place and all lined up with minimal effort!



Quite a bit of welding to do mind and there is still loads of work to be done before this finally gets attached, but it does look good! I was also pleased to see that the bottom lip repair I did some months back to the rear panel married up nicely also.

3 comments: