Heater Matrix Out!!

So after a lot of time (too much for my liking) I finally removed the heater matrix. The four screws that were putting up a strong fight had just about everything thrown at them, but in the end the two on the right hand side gave in to the heat of my wife's crème brulee blow torch. 

The other two bolts on the left hand side were more resistant to the heat so had to be removed by drilling off the heads and then using a star bit in a pre drill hole to unscrew the remaining bolt.

From then on it was more plain sailing and so I continued on with removing the wiring loom.

Until....Yes at last it was out!!!